The speed reducer lubrication oil
Lubricating oil
Working temperature range is not in the table, please contact with our technical staff.
◆ when working environment temperature below -30 ℃ or above 60 ℃, seal to use special materials
◆ working environment temperature is below 0 ℃, should be considered:
Selection of the motor, and must be able to work under low temperature;
Power, the motor must be satisfied at low temperature has larger starting torque requirements;
And if the reducer box body is made of cast iron, at a temperature of -15 ℃, box of very brittle, should pay attention to avoid the collision;
To use at the beginning stage, as a result of the oil viscosity is very high, may cause problems, so just started better let it no-load running a few minutes;
◆ reducer running about 5000 hours later, should replace the lubricating oil, oil change frequency according to reducer operation and work environment conditions; should pay attention to replace the oil, the oil can not be different
Mix;
The NMRV025 reducer, 0.30, 040, 050, 063, 075, 090 specifications is factory filled with a synthetic lubricants durable (SHELL TEVELA OIL 320),
According to the installation position samples mentioned in the installation position. V5 or V6 installation, please contact our technical service personnel;
◆ reducer NMRV110, 130, 150 specifications in the factory filled with a mineral oil (SHELL Omala Oil 460);
◆ CVT in the factory also added a mineral oil (wide Ub-3X);
The installation position of the reducer NMRV110, 130, 150 specifications described in place an order, otherwise the lubricating oil by B3 range;
